The energy-saving and intelligent characteristics of IMPRESIND gas radiant heating system-辐射板-红外线-热水辐射板-燃气辐射采暖-正弘奥能-伊普赛德-北京正弘奥能环保科技有限公司

The energy-saving and intelligent characteristics of IMPRESIND gas radiant heating system

time：2024-05-16
hits：412次
source：正弘奥能

Due to the large plant area, the steel structure plant heating poor, the environment is more transparent, determines its heating difficulties, in addition, even if the appropriate heating method is found, the cost of heating is also an important issue for users to consider. Therefore, it is a great challenge in the heating design of tall space industrial plants. 
 
With the development of science and technology, gas radiation heating equipment has overcome this problem. The height of the factory workshop is generally about 10 meters, and even up to 20 meters or more. The traditional convection heating principle is to heat the air first, and then heat the heat to the human body after the air in the whole room is heated. The infrared radiation heat emitted by the gas radiation heating equipment is to directly heat the human body or equipment, and then heat the air through the secondary radiation such as the human body or equipment. The heat distribution is uniform and the heating is rapid, which is very suitable for heating of tall space plants, and can achieve different temperature requirements in different areas of the same plant. This not only saves the cost of equipment, but also greatly saves the cost of use. 

	 


	 


	<img src="http://www.leadwaypower.com/Uploads/image/20240516/20240516100623_12572.jpg" alt="" /> 

 
IMPRESIND gas radiation heating equipment promoted and sold by Beijing Leadway Power Co., Ltd. uses natural gas and liquefied petroleum gas as fuel, and the heating generator is installed outside the building, which will not increase the fire rating of the building; The radiation tube is installed on the top of the tall space, and the heat energy is transferred directly from the top to the indoor ground, objects and personnel, and the heat is transferred in a directional manner, and the heating effect is better. Therefore, the system can be widely used in industrial plants, hangars, maintenance warehouses, warehouses, gymnasiums and other tall space places. 
 
In general, ordinary water heating, floor heating need 2 hours of preheating period, which is a great waste of energy, and IMPRESIND gas radiation heating equipment after opening a few minutes will have a warm feeling, half an hour or so will reach the required temperature. In addition, if you use a heater or traditional heating method, the top of the tall space will be evenly heated, but those Spaces actually do not need to be heated, so it also directly causes a waste of energy. Overall, in a heating season, IMPRESIND gas radiation heating can save 30%-50% of energy than traditional convection heating. 
 
IMPRESIND gas radiation heating equipment supporting the control system can achieve independent control or centralized remote control. Automatic control and temperature regulation are convenient and can realize partition control temperature. According to the needs of users, the temperature of different periods of 24 hours can be set, which can be used for global heating, but also for local heating, and can be set on duty heating temperature, there is no need to design special on duty heating. The intelligence of the heating equipment itself and the intelligence of the heating system can improve the operating efficiency and service life of the equipment, and reduce maintenance costs and energy consumption.