What's the way to improve the effect and comfort for heating in large-space industrial building?-辐射板-红外线-热水辐射板-燃气辐射采暖-正弘奥能-伊普赛德-北京正弘奥能环保科技有限公司

What's the way to improve the effect and comfort for heating in large-space industrial building?

time：2024-08-29
hits：245次
source：正弘奥能

With the continuous development of the construction field, the form and scale of industrial buildings have also been greatly developed, and the traditional convection heating method has also revealed its disadvantages. The single building is large in scale and the radiator layout is difficult to meet the design temperature requirements. The height of the building is high, and the phenomenon of heating on the radiator is serious. When the heater is used for heating, the wind disturbance in the workshop is serious and the temperature is uneven. 
 
Compared with the above convective heating system, increasing air exchange has less impact on the performance of the hot water radiant panel, because the radiation component is not affected by the air exchange, and the convective system mainly raises the air temperature to maintain comfortable conditions. Hot water radiant panels enable thermal comfort with appropriate air and average radiant temperatures, and without excessive vertical air temperature differences, temperature asymmetries, or excessive air flow. In the process of hot water circulation, the hot water radiant panel converts the medium heat into various wavelengths of infrared light through its radiant surface and radiates to the heating environment. The air temperature in the building is lower than the object temperature in the infrared irradiation area (generally 2-3 ° C lower), which reduces the air stratification and convection effect, and the heating system has a high utilization rate of heat energy and good comfort. Therefore, the hot water radiant panel heating system is superior to traditional convection heating equipment such as radiators and heaters, which can efficiently solve the problems of poor convection heating effect and high energy consumption in tall space. The practical application shows that it is a new energy-saving heating technology for tall space buildings. 
 
The hot water radiation panel runs without noise, without air disturbance, and avoids the ash phenomenon of air convection. Even in the industrial workshop where the smoke is relatively large, the staff will feel warm and comfortable. Because hot water radiant panels are ceiling-mounted or free-hanging, they do not take up valuable floor and wall space, making piping and installation less restrictive. Since the radiant energy is not significantly affected by the distance within the building, the hot water radiant panel can be applied to industrial workshops, warehouses, gymnasiums, garages, shops, hangars, aircraft maintenance depots, automobile exhibition halls, shipyards, offices and other tall space occasions. 
 
By Beijing Leadway Power Co., LTD. Promotion and sales of the ECOPAN hot water radiation panel is made of metal tube plate, in the factory is prefabricated into 3 meters, 6 meters (special requirements can be prefabricated 2 meters, 4 meters) standard length. Each radiant panel can be connected with a quick connector. Each radiant panel and collection pipe is prefabricated in the factory and tested for safety. With the same dimensional characteristics (pipe diameter, number and spacing, panel width), ECOPAN hot water radiant panels have higher thermal energy efficiency than other products on the market.